Safety Procedures And Notes Before Switching The Machine On - Skymsen LAR-15LMB Manual De Instrucciones

* Provide enough space for a comfortable and safe operation, thus avoiding accidents.
* Water or oil on the floor will make it slippery and dangerous. Make sure the floor is well
clean and dry.
* Before using any commands (switches, buttons, levers), be sure it is the correct one. In
case of doubt, consult this manual.
* Never touch any manual commands (switch, buttons, lever) unadvisedly.
* If any work is to be made by two or more persons, coordination signs will have to be
given for each operation step. Every step of the operation shall be taken only if a sign has
been made and responded.
4.1.3 Advices
* In case of power shortage, immediately switch the machine off.
* Use recommended or equivalent lubricants, oils or greases.
* Avoid mechanical shocks/impacts, once they may cause damages or malfunctioning.
* Avoid contact of water, dirt or dust to the mechanical and electrical components of the
machine.
* DO NOT change the standard characteristics of the machine.
* DO NOT remove, tear off or maculate any safety or identification labels. If any labels have
been removed or are no longer readable, contact your nearest dealer for replacement.

4.2 Safety Procedures and Notes before Switching the Machine ON

IMPORTANT
Carefully read all the INSTRUCTIONS of this manual before turning the machine
ON. Be sure to well understand all the information contained in this manual. If
you have any questions contact your supervisor or your nearest Dealer.
4.2.1 Danger
An electric cord or electric wire with damaged jacket or bad insulation might cause an
electrical shock as well as electrical leaks. Before use, check the condition of wires and
cord.
4.2.2 Advices
Be sure to well understand all the information contained in this manual. Every operation
function or procedure has to be thoroughly clear.
Before using any commands (switches, buttons, levers), be sure it is the correct one. In
case of doubt, consult this manual.
4.2.3 Precautions
The electric cord has to be compatible with the power required by the machine.
Cords touching the floor or close to the machine need to be protected against short circuits.
13