Analysis And Problem Solving; Problems, Causes And Solutions - Skymsen LAR-15LMB Manual De Instrucciones

5. Analysis and Problem Solving

5.1 Problems, causes and solutions

The Tilting Blenders have been designed to operate with minimum maintenance need.
However, some malfunctions may occasionally happen due to the natural wearing caused
by long use of the equipment.
If such problems occur with your Blender, refer to Table-02 in which the most common
situations are listed with recommended solutions.
PROBLEM
- The blender does no switch
ON.
- Burning smell or smoke.
- The blender starts, but after
to place the ingredients inside
the cup , the blender rotation
is too low.
- Damaged cord.
-Unusual noises.
-The product does not
process.
- Cup is leaking.
TABLE 02
CAUSES
- Electricity shortage.
- Problem with the
blender electric circuit.
- Problem with the blender
electric Circuits.
- Problem with the motor.
- Problem during transportation. - Call technical assistance.
- Damaged bearing
- Product pieces too large do not
allow contact with the knife.
- Blunt knife.
- Damaged seal.
SOLUTIONS
- Check electricity.
- Call technical assistance.
- Call technical assistance.
- Call technical assistance.
- Call technical assistance.
- Cut smaller pieces about 3,5
cm.
- Call technical assistance.
- Call technical assistance.
15