Quick Start; Menu Operation - DeFelsko PosiTector UTG Manual De Instrucciones

The PosiTector UTG is a hand-held Ultrasonic Thickness Gage that
uses the non-destructive ultrasonic pulse-echo principle to measure
the wall thickness of a wide variety of materials. It consists of a body
(Standard or Advanced) and probe.
Press the
life, the gage will automatically go to sleep after 5 minutes of
inactivity. While in Sleep Mode, the gage powers up significantly
faster— convenient when moving between parts or locations. The
gage will completely power off after 4 hours of inactivity.
Alternatively, select Power Off from the main menu. All settings
are retained.
1. Remove the protective rubber cap from the probe.
2. Power-up Gage by pressing the center navigation
3. Zero the probe (pg. 8).
4. Verify accuracy and adjust if necessary (pg. 7).
5. Measure the part (pg. 5).
To access the Menu, power-up the gage, then press the center
navigation button
used to navigate the menu. If desired, touch screen functionality
can be disabled within the Setup menu (See Touch, pg. 12).
Select a menu option by touching it, or use the
tons to highlight the desired option and press
On menus longer than one page, the current page number is dis-
played below the menu name. Navigate between pages using
when the first menu item is selected, or
menu item is selected. If using touch, navigate between pages
by touching
Press the button or swipe right to return to a previous screen.
Select Exit to close the Menu.
Introduction

Quick Start

button to power up the Gage. To conserve battery

Menu Operation

. Either the keypad or touch screen can be
or , or by swiping up or down.
1
button.
and but-
to select it.
when the last