Kohler K-856-V Guia Del Usuario página 7

Operation (cont.)
Rotate the outer ring to select the chromatherapy mode, then press OK to activate the
chromatherapy lights. Press OK while the chromatherapy mode is active to turn off the
chromatherapy lights.
Rotate the outer ring to select chromatherapy specific color selection, then press OK. Use the UP or
DOWN arrow to reach the desired color. Press OK while the chromatherapy specific color selection
is active to turn off the chromatherapy lights.
Neckjets
NOTE: Before activating the neckjets, make sure the slip cover is in place on the pillow and the pillow is
attached to the neckjet body. If the pillow is not properly installed the neckjets will stop. The neckjet icon
and indicator bar on the user keypad will flash. The neckjets will automatically restart when the pillow is
properly installed.
Rotate the outer ring to select the neckjet mode, then press OK to activate the neckjets. The neckjet
pulsing action will start at medium speed. Press the UP or DOWN arrow to adjust the pulsing
action.
Rotate the outer ring until the flow mode is flashing, the press OK. Press the UP or DOWN arrow to
adjust the water flow volume of the neckjets.
Press OK while the neckjet mode is active, to turn off the neckjets.
NOTE: To activate or deactivate functions while the neckjets are operating, rotate the outer ring until the
desired function is flashing and press OK.
Backjets
Rotate the outer ring until the backjet icon is flashing and press OK. The backjet pulsing action will
start at medium speed. The backjets pulse from the bottom of the whirlpool toward the top, with
water flow and pulse action occurring from two backjets at a time.
NOTE: If the water level falls below the water level sensors, the backjets will stop. The backjet icon and
indicator bar on the user keypad will flash. The backjets will automatically restart when the water level
covers the sensors.
To increase or decrease the backjet pulsing action, press either the UP or DOWN arrow on the
keypad while the backjet mode is active.
To increase or decrease the flow volume to the backjets, rotate the outer ring to the Flexjet mode,
press OK to activate the mode, and press either the UP or DOWN arrows on the keypad. This also
increases or decreases the flow to all modes.
Press OK while the backjet mode is active, to turn OFF the backjets.
Kohler Co. 7 1023276-5-D