Husqvarna 591111301 Manual Del Propietário página 6

2
MOUNTING COVER ASSEMBLY TO
SUPPORT ASSEMBLY (See Fig. 2)
NOTE: For ease of assembly, you may wish to obtain the
assistance of another person for mounting cover assembly
to tractor.
1. Position cover assembly on ground behind tractor.
2. Lift and rotate cover to align cover brackets with support
assembly tubes.
3. Slide cover assembly down onto the support tubes.
COVER
ASSEMBLY
03024
SUPPORT
ASSEMBLY
FIG. 2
3
CONTAINER MOUNTING (See Fig. 3)
1. Install one container to left side first. Install another
container to center position and one in right position.
NOTE: Left edge of right container should always overlap
right edge of left container at center supports.
2. Close cover and lock latches over center support tubes.
To lock and release latches, pull back on latch handles.
COVER LATCH
HANDLES
CONTAINER
HANDLES
6
CENTER
SUPPORT
TUBES
FIG. 3