Blade Assembly; Light Kit Assembly. Pgs - Craftmade Ellington DCF52BNK5C1 Guia De Instalacion

9. Blade Assembly.

Time Saver: Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and
washers in one of the hardware packs. Hold
blade arm up to blade and align holes. Insert 3
blade attachment screws (along with washers)
with fingers first and then tighten screws
securely with a Phillips screwdriver. Repeat for
the remaining blades.
Remove blade arm screws and lock washers
from underside of motor. If plastic motor locks
are installed with blade arm screws, discard
plastic motor locks (save blade arm screws and
lock washers to secure blade arms). Align blade
arm holes with motor screw holes and attach
blade arm with lock washers and blade arm
screws. Before securing screws permanently,
repeat with remaining blade arms. Securely
tighten all screws.
NOTE: Tighten blade arm screws twice a year.
10. Light Kit Assembly.
Remove 3 screws from switch housing cap.
If you wish to use fan WITHOUT the light kit, align
holes in switch housing cap with holes in switch
housing. (Note: The gap on the top edge of the
switch housing cap must align with the reverse
switch on the switch housing for the proper fit.)
Secure switch housing cap with 3 screws that were
just removed.
Please proceed to Section 11 on the next page to
complete installation WITHOUT the light kit.
If you wish to use fan WITH the light kit, locate
BLACK (or BLUE) and WHITE wires in switch
housing labeled FOR LIGHT.
Remove hex nut and lock washer from threaded rod
on light kit fitter. Punch center cap out of switch
housing cap with a screwdriver. Feed wires from
light kit fitter through center hole in switch housing
cap. Then, screw switch housing cap onto threaded
rod followed by lock washer and hex nut. Tighten
hex nut over lock washer for a secure fit.
["Light Kit Assembly" continued on next page.]
plastic
motor
lock
lock washers
blade arm
screws
switch housing
white wire
switch housing
cap
hex nut
lock washer
page 7
blade screw and washer
motor housing
blade attachment
screws and washers
blade
blade arm
motor housing
black (or blue)
wire
center cap
switch housing cap
light kit fitter