Light Kit Assembly (Optional). Pgs - Craftmade Manor MAN52-4 lights Guia De Instalacion

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

9. Light Kit Assembly (Optional).
Remove 3 screws and star washers from switch
housing cap.
If you wish to use your fan WITHOUT the light kit,
align holes in switch housing cap with holes in
switch housing. (Note: The gap on the top edge of
the switch housing cap must align with the reverse
switch on the switch housing for the proper fit.)
Secure switch housing cap with 3 screws that were
just removed. Please proceed to Section 11 on the
following page to complete installation without
light kit.
If you wish to use your fan WITH the light kit,
locate BLACK (or BLUE) and WHITE wires in
switch housing labeled FOR LIGHT. Remove and
discard plastic that holds these 2 wires together.
Remove the hex nut and lock washer from
threaded rod in light kit fitter. Punch center cap
out of switch housing cap with a screwdriver. Feed
wires from light kit fitter through center hole in
switch housing cap. Screw switch housing cap
onto threaded rod on light kit fitter followed by
lock washer and hex nut. Tighten hex nut over
lock washer for a secure fit.
["Light Kit Assembly" continued on next page.]
switch housing
switch housing
cap
hex nut
lock washer
threaded
rod
page 8
motor
housing
switch housing cap
center cap
light kit fitter

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido