Testing Your Fan - Craftmade Manor MAN52-4 lights Guia De Instalacion

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

9. Light Kit Assembly (Optional). (cont.)
Connect BLACK (or BLUE) wire from switch
housing to BLACK wire from light kit fitter.
Connect WHITE wire from switch housing to
WHITE wire from light kit fitter. Be sure that
molex connections snap together securely.
Align holes in light kit fitter with holes in switch
housing. (Note: The gap on the top edge of the
switch housing cap must align with the reverse
switch on the switch housing for the proper fit.)
Attach light kit fitter with screws that were
removed on previous page. Securely tighten all
3 screws with a Phillips screwdriver.
Attach 4 glass shades using thumbscrews
provided in one of the hardware packs. Do NOT
overtighten thumbscrews as glass may crack or
break.
Install 4 candelabra base 40 watt max. bulbs
(included).
Important: When replacing bulbs, please allow
bulb(s) and glass shade(s) to cool down before
touching them.

11. Testing Your Fan.

It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test fan speeds with the pull chain
on switch housing. Start at the OFF position (no blade
movement). First pull will set the fan to HI. Second pull will
set the fan to MEDIUM. Third pull will set the fan to LOW.
Fourth pull will re-set the fan to OFF setting. Test lights
with pull chain in the middle. If fan and/or lights do (does)
not function, please refer to "Troubleshooting" section to
solve any issues before contacting Customer Service.
Turn fan completely off before moving the reverse switch.
Set reverse switch to recirculate air depending on the
season:
- DOWN position in summer (diagram 1)
- UP position in winter (diagram 2)
A ceiling fan will allow you to raise your thermostat setting
in summer and lower your thermostat setting in winter
without feeling a difference in your comfort.
Important: Reverse switch must be set either completely
UP or completely DOWN for fan to function. If the reverse
switch is set in the middle position (diagram 3), fan will
not operate.
Attach pull chain extensions supplied or custom pull chain
extensions (sold separately) to the ends of the pull chains.
reverse
switch
switch
housing
molex connections
white wire
light kit fitter
diagram 1
page 9
motor
housing
black
(or blue)
white
wire
wire
pull chain extension
for fan
black wire
glass shade
bulb
light pull chain
extension
diagram 2
thumb-
screws
diagram 3

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido