Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Heating zones of the same
side ( Such as the first and
the second zone ) would
display "u" .
Fan motor sounds
abnormal.
The above are the judgment and inspection of common failures.
Please do not disassemble the unit by yourself to avoid any dangers and damages to the induction hob.
9. Installation
9.1 Selection of installation equipment
Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 50mm space shall be preserved around the hole.
Be sure the thickness of the work surface is at least 30mm. Please select heat-resistant and insulated
work surface material (Wood and similar fibrous or hygroscopic material shall not be used as work
surface material unless impregnated) to avoid the electrical shock and larger deformation caused by
the heat radiation from the hotplate. As shown below:
Note: The safety distance between the sides of the hob and the inner surfaces of the worktop
s
should be at least 3mm.
A(mm)
B(mm)
268
500
＋4
＋4
-0
-0
Under any circumstances, make sure the Induction cooker hob is well ventilated and the air inlet and
outlet are not blocked. Ensure the Induction cooker hob is in good work state. As shown below
Note: The safety distance between the hotplate and the cupboard above the hotplate should be at
least 760mm.
The power board and
the display board
connected failure;
The display board of
communicate part is
damaged.
The Main board is
damaged.
The fan motor is
damaged.
C(mm)
D(mm)
50min.
50 min.
19
restart unit.
Check the connection.
Replace the display
board.
Replace the power board.
Replace the fan.
E(mm)
F(mm)
50 min.
50 min.
G
3mm min.
V.1
Publicidad
Capítulos
Tabla de contenido
