Surface Temperatures - Beurer FT 95 Manual De Instrucciones

If Bluetooth is active on the thermometer and it is paired with your mobile device, measurements will
transfer to the Beurer HealthCoach mobile app. The Bluetooth® symbol will flash on the LCD Display
while the thermometer attempts to connect to the app for about 30 seconds. The Bluetooth icon will
stop flashing when the thermometer connects to your device's mobile app and stored measurements
will then transfer. Afterwards, the thermometer will shut off after 60 seconds, or press the ON/OFF
Button to shut it off manually.
Viewing Stored Measurements
This device stores 60 measurements, along with the date/time and "fever"/"no fever" classification.
With the device switched on, press and hold the MODE/MEM button for about three seconds; the
most recent measurement will display. Press the MODE/MEM button repeatedly to cycle through
the older measurements.

Surface temperatures:

To measure the surface temperature of an object, change the thermometer to Object Temperature
Mode.
1� Press the ON/OFF Button to switch the thermometer on. Change the
thermometer to surface temperature mode by pressing the MODE/
MEM Button. The object temperature mode icon will display.
18