Step 6. Level The Range - Samsung nx60a6511ss Manual De Instalación

Installation instructions

Step 6. Level the range

Leveling leg
20 English
Install_NX60A6_DG68-01337A-00_EN+MES+CFR.indb 20 Install_NX60A6_DG68-01337A-00_EN+MES+CFR.indb 20
1. Make sure the range is positioned where
you want it.
2. Using a wrench, level the range by
turning the front leveling legs in or out
as necessary. Counterclockwise shortens
the leg and lowers the range. Clockwise
lengthens the leg and raises the range.
NOTES
• Adjusting the two front legs is usually
sufficient, but adjust all four legs if
necessary.
• Adjust the leveling legs only as far as
necessary to level the range. Extending
the leveling legs more than necessary or
removing legs can cause the range to be
unstable.
3. If range is next to or between cabinets,
make sure the cooktop (without the
surface burner grates) is level with the
countertops.
4. Position an oven rack in the center rack
position.
5. Check the level of the range with a
carpenter level using the two positions
shown at right.
6. After the range becomes level, slide the
range away from the wall so that the
anti-tip bracket can be installed.
Check your adjustments
Use a level to check your adjustments. Place
the level diagonally on the oven rack or
surface cooktop, and confirm the range is
level in the two directions shown below.
A.
B.
If the level indicates that the range is not
level, adjust the leveling legs with a wrench.
Check direction 1.
Check direction 2.
2020-12-30 2020-12-30 10:56:13 10:56:13