Step 7. Assemble The Surface Burners; Step 8. Check The Ignition Of Surface Burners - Samsung nx60a6511ss Manual De Instalación

Step 7. Assemble the surface burners

Precise Simmer Burner (RR)
Flat surface Concave line
Install_NX60A6_DG68-01337A-00_EN+MES+CFR.indb 21 Install_NX60A6_DG68-01337A-00_EN+MES+CFR.indb 21
CAUTION
Do not operate the surface burners without
all burner parts in place.
1. Position surface burner heads on top of
the surface burner manifolds as shown at
left. The electrodes will fit into the slot in
the bottom of the heads. Make sure the
surface burner heads are flat and parallel
with the cooktop.
2. Place the matching size caps on top of
each surface burner head.
NOTE
The caps on Precise simmer burner
(RR) and inside Dual Burner (RF) can be
interchangeably used.
3. Place the left, center, and right surface
burner grates on the cooktop. The edges
of the grates should match up with the
edges of the cooktop.

Step 8. Check the ignition of surface burners

Check the operation of all cooktop and oven burners after the range has been
installed and assembled, gas supply lines have been carefully checked for leaks,
and electrical power cord has been plugged in.
All surface and oven burners have electronic ignition.
To turn on a surface burner:
1. Push in and turn the control knob for that
2
1
2. After the burner lights, turn the control
3. Repeat steps 1 and 2 to check the
surface burner to the Lite position. The
"clicking" sound indicates the electronic
ignition system is operating properly. The
burner will light in about 4 seconds, after
the air has been purged from the supply
line.
knob to the desired setting. The "clicking"
sound will stop and the flame height will
change from Max. to Min. during turning
the control knob.
operation of each surface burner in
succession.
English 21
2020-12-30 2020-12-30 10:56:14 10:56:14