Installation requirements
Recommended locations for gas piping and electrical outlets
(For Gas Free-Standing Range)
Gas Wall Area
Gas Wall Area
Recommended area for
Recommended area for
through-the-wall and through-
through-the-wall and through-
the-floor connection of gas
the-floor connection of gas
pipe stub and shut-off valve.
pipe stub and shut-off valve.
9 in
9 in
(22.9 cm)
(22.9 cm)
2 in
2 in
(5.1 cm)
(5.1 cm)
14 English
Install_NX60A6_DG68-01337A-00_EN+MES+CFR.indb 14
Install_NX60A6_DG68-01337A-00_EN+MES+CFR.indb 14
Recommended
Recommended
position
position
17 in
17 in
(43.2 cm)
(43.2 cm)
12 in
12 in
(30.5 cm)
(30.5 cm)
Recommended area for
Recommended area for
120 V electrical outlet
120 V electrical outlet
on rear wall
on rear wall
To avoid breakage
Please DO NOT push the unit strongly when
you install. These actions can cause the
damage to the unit.
Please DO NOT push the burner knobs when
installing the range.
(Grasp the L/R door area to push the unit.)
CAUTION
Do NOT lift or handle the unit by the cooktop frame.
1. The counter top around the cut-out
2. Before installing the unit, measure the
3. Level the range using the four leveling
C2
C1
C4
C3
4. Slide the unit into the cabinet (DO NOT
Fig. 1
CAUTION
should be flat and leveled (See hatched
area on Fig. 1).
heights of the two cabinet sides (C1 ~ C4),
front and back (See Fig. 1) from the floor
to the top of the counter.
legs so that the height from the floor
to the underside of the cooktop frame
is greater than the tallest cabinet
measurement by at least
/
".
1
16
PUSH THE UNIT HARD). Make sure the
center of the unit aligns with the center
of the cabinet cut-out.
2020-12-30
2020-12-30
10:56:12
10:56:12