Starting A Wash Cycle - Danby DDW631WDB Manual Del Propietário

OPERATING INSTRUCTIONS

STARTING A WASH CYCLE

1. Load the dishwasher as per the loading
instructions.
2. Add detergent and rinse aid as required.
3. Ensure the dishwasher is connected to a water
supply and that the water is turned on.
4. Insert the plug into the power supply.
5. Close the dishwasher door and press the power
button to turn on the appliance.
6. Press the Program button repeatedly to choose
the desired wash program. The programs will
cycle in the following order: Heavy -> Normal
-> Baby Care -> ECO -> Glass -> Speed ->
Rinse -> Mini-Party
7. Press the Start/Pause button to begin the cycle.
ADDING A FORGOTTEN DISH
A forgotten dish can be added to a running cycle
any time before the detergent dispenser has
opened. If the detergent has already been released
into the appliance, it is recommended not to add
more dishes as they will not receive adequate
cleaning.
To add a dish:
1. Press the Start/Pause button to pause the cycle.
2. Open the door slowly as the spray arm may still
be turning.
3. Add the forgotten dishes.
4. Close the door.
5. Press the Start/Pause button to resume the cycle.
The appliance can take up to 10 seconds to
restart.
ENDING A WASH CYCLE
When a wash cycle is completed, a buzzer will
sound for 8 seconds, then stop. The appliance will
automatically turn off after 30 minutes of inactivity.
To turn off and unload the dishwasher:
1. Press the power button to turn the appliance off.
2. Turn off the water supply and unplug the
appliance from the power source.
3. Allow the appliance to remain undisturbed with
the door closed for approximately 5-10 minutes
at the end of a cycle. Opening the door too
quickly while the internal temperature is still very
hot can cause fl ash drying which can leave spots
and streaks on dishes.
4. Open the door carefully as the air inside the
appliance can still be hot. Leave the door ajar
for a few minutes before removing dishes to
allow them to cool and dry. Hot dishes can be
sensitive to knocks and may break; they should
be allowed to cool before removing from the
appliance.
Note: There is no drying cycle in this appliance.
Dishes should be left inside the unit for a short
period after a cycle so that the warm air inside
the appliance can assist in the drying process. It
is normal for dishes to still be wet at the end of a
cycle.
Note: It is normal for a small amount of water to
remain inside the appliance at the end of a cycle.
This water will evaporate and does not need to be
manually drained.
10