Error Codes - Danby DDW631WDB Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CARE & MAINTENANCE
CLEANING
• Unplug the appliance from the power source
before completing any cleaning or maintenance.
• After every wash, turn off the water supply and
leave the door slightly open so that moisture and
odors are not trapped inside the appliance.
• Only use a soft cloth and mild detergent to
clean the appliance. Never use solvents or
abrasive cleaning agents as this can damage
the appliance.
• To remove water spots from the interior of the
appliance, use a soft cloth dampened with a
small amount of vinegar.
• If the appliance will not be used for a long
period of time, it is recommended to run a
normal wash cycle with the dishwasher empty
and then leave the door open until the interior
of the appliance is completely dry. This will help
the door seals last longer and will help prevent
odors from forming inside the appliance.
• Clean the door seals with a damp sponge
regularly to prevent odors from food particles
that can become trapped in the door seal.

ERROR CODES

E1: Not enough water getting into the unit
• The water source is not turned on
• Water intake is restricted
• Water pressure is too low
E3: Not reaching correct temperature
• Malfunction of heating element
E4: Water overfl ow
• Drain malfunction
• Drain clog
Ed: Control board malfunction
• Internal communication error
If the appliance displays any error code, a power
reset may resolve the issue. Unplug the appliance,
wait approximately 5 minutes and then plug the unit
back in.
12

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ddw631sdb

Tabla de contenido