Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6. Fan Assembly (flushmount). (cont)
If there are only 3 screws in top of motor housing,
please proceed to next paragraph. If there are 6
screws in top of motor housing, remove every other
screw and star washer.
Remove pin, clip and set screws from motor housing
yoke. Thread wiring through canopy ring and
canopy. Place canopy over yoke aligning larger holes
in canopy with the 3 existing screws in top of motor
housing. Insert the 3 screws and 3 star washers that
were removed (if there were only 3 screws located in
top of motor housing, these screws/star washers will
be located in one of the hardware packs) into the
remaining holes. Securely tighten these screws.
To prepare the fan for wiring, hang fan onto hanging
bracket by sliding the canopy over the hanging
bracket tab. (Use one of the non-slotted holes on the
rim of the canopy to do so.)

7. Wiring.

CAUTION: Be sure outlet box is properly grounded
and that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to below, please use a
qualified electrician.
Note: Excess lead wire length from the fan can be cut
to the desired length and then stripped.
When downrod is secured in place on the hanging
bracket, electrical wiring can be made as follows:
Connect BLACK and BLUE wire from fan to BLACK
wire from ceiling with wire connector provided.
Connect WHITE wire from fan to WHITE wire from
ceiling with wire connector provided.
Connect all GROUND (GREEN) wires together
from fan to BARE/GREEN wire from ceiling with
wire connector provided.
If you intend to control the fan light with a
separate light switch, connect BLUE wire from fan
to the BLACK (or RED) supply from the
independent switch.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
set screw
clip
motor
housing
white supply wire
black supply wire
from ceiling
black
white
wire
connectors
white
black
blue
from fan
This fan is remote control adaptable (remote
control sold separately).
page 6
canopy
yoke
motor housing
canopy
hanging bracket
ground
(green or bare)
wire
connector
ground
(green
or bare)
*
pin
tab

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido