Reassembling; Storing; Troubleshooting - Levoit Classic 300S Manual Del Usuario

EN

Reassembling

Flip the water tank over and place
1.
the noise silencer back into the tank.
[Figure 4.18]
Figure 4.18
2. Place the float back into the base
chamber:
Make sure the correct side of the
a.
float is facing up. [Figure 4.19]
Figure 4.19
24
Insert the smaller prong into the
b.
closed side of the float brackets.
[Figure 4.20]
Figure 4.20
c. Place the larger prong into the
open (U-shaped) side of the float
brackets.
3. Place the tank back on the base. Refill
the tank, if necessary.
4. Place the tank properly on the base and
place the tank cover on the water tank.

Storing

Follow the cleaning instructions (see page
19) and allow all parts to dry completely
before storing. Store in a cool, dry location.
T R O U B L E S H O OT I N G
Problem Possible Solution
Plug in the humidifier and turn it on.
Add purified or distilled water to the water tank.
Humidifier doesn't turn on,
or turns off unexpectedly.
Check to see if the humidifier is in Auto Mode. Depending on Auto Mode
settings, the humidifier may automatically turn off when the humidity
level is above the target level.
Turn the mist level to a higher setting.
Fill the water tank.
There may be too much water in the base chamber. Empty the base
chamber. Refill the water tank (not the base chamber) and place the
water tank properly onto the base.
Make sure the air inlet on the bottom of the base is not blocked. The
humidifier should not be set on carpet or other surfaces that may block
the air inlet.
Little or no mist comes out.
Make sure the nozzle is not blocked or clogged.
Make sure the humidifier is on a level surface.
The water temperature may be too low. Turn the mist level to the highest
setting and let the humidifier run for a while, then adjust to the desired
setting.
If the water tank or base was washed with detergent, rinse thoroughly
with clean water to remove any detergent.
The humidifier uses up water based on the environmental temperature
Humidifier uses water too
and humidity. If your environment is cold and/or dry, the humidifier will
quickly.
run out of water faster.
If the humidifier is new, unplug and rinse all parts, then place in a cool,
dry place for 12 hours.
Humidifier produces an If essential oils were placed on the aroma pad, rinse the pad under clean
unusual smell. water and allow it to dry.
Clean the water tank and base chamber (see
page 19).
EN
Care & Maintenance,
25