Descargar Imprimir esta página

Antec PERFORMANCE 1 Manual Del Usuario página 6

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

5. Connect the FPOUT-L connector to the Front Left Speaker Out Pin.
6. Connect the RET-R connector to the Rear Right Speaker Out Pin.
7. Connect the RET-L connector to the Rear Left Speaker Out Pin.
Note: If your motherboard doesn't support rear speaker output, you don't
need to connect the RET-R or RET-L connectors.
Connecting the Temperature Display Sensor
There are two temperature sensors connected to the front display. Every 3
seconds, the temperature display cycles automatically between them.
1. There are two 30" (76 cm) long temperature sensor wires. For best
temperature monitoring, we suggest you connect one sensor to the hard
drive and the other to the motherboard.
2. There is a 26" (66 cm) long cable with a switch connected to the front
control panel. The switch toggles the temperature display between
Celsius (C°) and Fahrenheit (C°). The default setting is Celsius (C°).
Installing 5.25" Devices
The P160W features four external 5.25" drive bays. You'll find the drive rails
inside the toolbox.
1. Carefully remove the sheet metal covering the drive bay by twisting it back
and forth until it separates from the case. Watch your fingers; when you
remove the sheet metal, there may be a sharp metal burr remaining where
the plate was attached.
2. Mount two drive rails onto the sides of the 5.25"
device. Make sure the metal tab angles out away
from, and faces towards, the front of the device.
Note: If you want to mount your drive flush to the
front bezel, use the first screw hole on the rails
(marked #1 in Photo 2) to mount the drive rails. If
you want to use one of the color-coordinated
CD- ROM cover plates, mount the rails with the second
screw hole (marked #2 in Photo 2). The plates are included with the P160.
3. Slide the device into the drive bay until you hear a click.
4. Mount the other devices accordingly.
5. Connect a large 4-pin white connector from the power supply to the male
4-pin connector on each of the devices.
Installing External 3.5" Devices
You'll find two external 3.5" drive bays underneath the 5.25" drive bays.
1. With the front bezel removed, unscrew the two thumbscrews at the sides
of the 3.5" drive tray and pull the 3.5" drive tray out of the case.
2. Mount your floppy drive or other external device in the drive tray. If
needed, repeat the same procedure for the other drive. Note: We've
included one color-coordinated floppy drive cover plate with the P160W. If
you want to use the cover plate, leave enough room for it when mounting
the drive (as indicated by #1 in Photo 3). If you want your device to sit
flush to the bezel front, use the other set of mounting holes (as indicated
by #2 in Photo 3).
5
#1
#2
Photo 2

Publicidad

loading

Este manual también es adecuado para:

P160w