Any use other than the intended use is considered incorrect use. The legal warranty is voided by any
interference with, or modifications to, the device.
Danger due to insufficient wire cross-section!
If wires with an insufficiently large cross-section are used, short circuits or fires may occur.
WARNING!
−
Only use terminals with a cross-section between 1 mm² and 2.5 mm² for flexible wires.
Damage to the channel extension due to incorrect installation location!
If installed in an unsuitable location, the channel extension may be damaged.
NOTICE!
−
Only use the channel extension in dry rooms and do not install close to devices with
inductive discharge (motors, transformers, etc.).
−
Only install the channel extension on DIN rails.
Residual risks
The device is state-of-the art and designed in accordance with current safety requirements. However,
residual risks remain that require caution when using the device. The residual risks, and the conduct and
measures they require, are listed in the following.
FCC Certification
FCC ID: 2AHH/-DG
This device complies with Section 15 of the FCC Regulations. Operation is only permitted under the fol-
lowing conditions: (1) This device must not cause any disruptive interferences and (2) the device must be
able to receive interferences, also such interferences which could result in undesired operations.
Electric current
Danger to life due to electric shock!
Improper assembly and installation of the device can lead to life-threatening electrical vol-
WARNING!
tages.
−
Have assembly and connection performed by a qualified electrician only.
EN
38