Flex RS 13-32 Instrucciones De Funcionamiento Originales página 17

RS 13-32 / RSP 13-32
In general, select a high stroke number for
cutting wood.
A lower stroke number is required for cutting
metal and plastic.
Setting the stroke type
Two stroke types can be selected: Straight
stroke and pendulum stroke.
Straight stroke
The saw performs horizontal movements
only. Particularly suitable for cutting metal.
If a very good cross-section is required when
sawing wood, also use the straight stroke.
180° rotation of pendulum stroke
The saw performs horizontal and vertical
movements (pendulum movements). The
stroke type is particularly suitable for cutting
wood quickly.
Infinitely adjustable stroke height (stage 1-3):
Stage
1
2
3
Adjusting the cutting support
WARNING!
Before performing any work on the power
tool, pull out the mains plug.
The cutting support should always rest on
the material when sawing so as to avoid
excessive vibrations.
It is possible, for example, to limit the saw
blade cutting depth by adjusting the cutting
support.
 Push cutting support lock (1.).
 Adjust the cutting support to the required
depth (2.).
Stage 0
Stroke height
1 mm
2 mm
3 mm
 Release cutting support lock.
Switching the power tool on/off
The power tool switch allows the operator
to increase the stroke rate slowly up to the
maximum setting.
 Press and hold down the switch.
The power tool starts.
The LED illuminates the working area when
the power tool is switched on.
To switch off the tool:
 Release the switch.
Operating instructions
WARNING!
Always hold the power tool firmly with both
hands!
 Whenever possible, clamp the workpiece
to be cut in a vice.
17