To Stop The Engine; To Spray; Spraying Procedure; Cleaning After Completion Of Spraying - Husqvarna 321S15 Manual De Usuario

IMPORTANT
• If the rope is pulled continuously with the choke closed,
the spark plug may become fl ooded and the engine
may fail to start. If so, you should fi rst remove the
spark plug and dry the electrodes, then repeat the
starting procedure.

To stop the engine

WARNING
• Stop the engine immediately in the event of an emer-
gency.
1. Lower the throttle lever (12) fully and cool the engine
down for 1-2 minutes at low speed.
2. Hold down stop switch (11) on the left side of the spray-
er frame until the engine has come to a complete stop.
12
11
IMPORTANT
• Except for an emergency, avoid stopping the engine
while pulling the throttle trigger.

To spray

WARNING
• Please use correctly, observing the precautions in
this manual.
• Before lifting the sprayer onto your back, check that the
sprayer tank cap and fuel tank cap are tightly closed.
• When spraying, do not point the nozzle at your face,
or at other people, animals, etc.
• If the sprayer is tilted too much, chemical fl uid or fuel
may leak out through the air holes in the cap. When
using, always try to maintain an upright posture.
IMPORTANT
• If the sprayer tank becomes empty while spraying,
reduce the engine to low speed immediately. Empty
running of the engine may cause the spray pump to
break.
• Please avoid using multiple nozzles, jet nozzles,
or other nozzles that give a large spray volume, as
spraying effi ciency is sometimes impaired owing to
insuffi cient pressure.

Spraying procedure

1. Start the engine,
2. Lift the sprayer onto your back.
3. Adjust the carrying band to a suitable length for
carrying.
4. Increase the engine speed,
5. Open the cock valve (3). Chemical fl uid starts to spray
out from the nozzle in the form of mist.
6. When stopping work, close the cock valve (3) fully and
reduce the engine speed.
b
b
3

Cleaning after completion of spraying

1. Loosen the fl uid drain cap , transfer the chemical fl uid
left inside the tank into a suitable container, and pro-
cess appropriately with all due consideration to safety.
2. Pour about 5 litres of clean water into the sprayer tank,
spray through the nozzle for 2-3 minutes, and drain
the water left inside the tank.
321S15/25
a
a. open
b. close
GB-13