Enraf Nonius CURAPULS 670 Manuel De Instrucciones página 51

P
ARAMETERS
T P (
HE EAK POWER
The Peak power (or Pulse power) is the "height" of the pulse. This means the amount of
Watts delivered during the time that the pulse is "on". This parameter is adjustable per 5
Watt.
Circuplode 90
Circuplode 140
Circuplode E
P
ULSE REPETITION RATE
Pulse repetition rate (or Pulse Frequency) is the number of times that a pulse is "on" per
second.
Circuplode 90
Circuplode 140
Circuplode E
M :
EAN POWER
The mean power is determined by the peak power, the pulse duration and the pulse
repetition rate.
The mean power resulting from the parameters is calculated and displayed when the device
is in conventional mode.
(When the device is in smart mode, the mean power can be selected. The device will choose
the appropriate parameters based on best available evidence).
Range:
Circuplode 90
Circuplode 140
Circuplode E
64 Watt is the maximum total output for the 2 channels combined.
For example, if on one channel a Circuplode E is delivering 50 Watt, the Circuplode on the
second channel can only be programmed to deliver up to 14 Watt.
Note: If the selected total output power is more than 64W, the unit displays an error
message "The combined output power is too high".
P :
ULSE DURATION
Pulse duration is the time that one pulse is "on" expressed in microseconds (us). This could
be explained as the width of a single pulse
Range: 65-400 μs
Treatment time: up to 30 minutes.
EN109-1670750-46 IFU
P ):
OR ULSE POWER
0-100 Watt
0-200 Watt
0-200 Watt
/ (P -)F
ULSE REQUENCY
26-400 Hz
26-400 Hz
26-800 Hz
0-32 W
0-32 W
0-64 W
Page 17 of 34
:
ENGLISH