Enraf Nonius CURAPULS 670 Manuel De Instrucciones página 54

M O
ANUAL PERATION
9. The Mean power can be adjusted using 
buttons or by using the slider bar.
Select the position on the slider bar based on the
character of the indication (Acute to Chronic scale)
or the need for a non-thermal or thermal
treatment. The corresponding Mean power will be
displayed
The device will set the appropriate underlying
parameters for you (Pulse repetition frequency,
Pulse duration and Peak power).
10. Press to accept and go back to the
treatment screen.
S 2-S
CENARIO MART
1. When the smart mode is off, all parameters
can be set independently.
2. Treatment parameters will be displayed for
the active Channel tab.
3. In the example above, the active tab is channel
A. Press Channel Tab B to access the parameter
settings for that channel.
4. Total treatment
frequency, Pulse duration, Peak power and the
calculated Mean power are displayed.
5. Press the parameter you want to adjust. A new
screen will open to allow you to select the right
value.
6. Adjust the value using the buttons or
select one of the pre-set values.
7. If the mean power changes as a result of the
selected parameter, this will be displayed too.
EN109-1670750-46 IFU
M O
ODE IS FF
time, Pulse repetition
Page 20 of 34
ENGLISH