Maintenance And Troubleshooting; Cleaning And Disinfection - Enraf Nonius CURAPULS 670 Manuel De Instrucciones

12 MAINTENANCE AND TROUBLESHOOTING

C D
LEANING AND ISINFECTION
Before performing any user maintenance, switch off the device and disconnect the plug
from the mains supply.
Do not spray the cleaning agent directly on the glass panel.
Do not use cleaning agents that contain strong alkalis, lye, acid, detergents with
fluoride or detergents with ammonia.
Use no liquid detergents, these can damage the device.
Do not allow any liquids to penetrate the unit or its accessories while cleaning and
disinfecting!
Dry all sockets and connectors that have become wet before any further use!
Mechanical shocks /or vibrations MUST be avoided while cleaning the Circuplode!
Do not drop the Circuplode!
Device Clean the unit with a damp cloth.
Do not use abrasive cleaners.
Display Panel The display panel contains an anti-reflective coating, which needs special
care when cleaned. Use a soft and dry cotton cloth or micro fiber tissue to
clean the panel. To remove fingerprints or grease, use a non-abrasive glass
cleaning agent. Apply a small amount of the cleaning agent to a soft cotton
cloth and then carefully clean the panel.
Circuplode Clean the Circuplode with a moist cloth.
Do not use abrasive cleaners
T
ROUBLESHOOTING
In the event that an error message or Warning appears, immediately stop all use of
the unit and contact the supplier or Enraf-Nonius B.V. for service. Errors and
Warnings indicate an internal problem with the unit that must be tested by a field
service technician certified by Enraf-Nonius B.V before any further operation or use
of the system.
Use of a unit that indicates an Error or Warning may pose a risk of injury to the
patient, user, or extensive internal damage to the system.
In case of display failure or other obvious defects, unplug the unit immediately and
notify a certified service technician.
EN109-1670750-46 IFU
Page 24 of 34
ENGLISH