Technical Data - Uebler i21 Instrucciones De Montaje Y De Uso

Technical data

Maximum load (bearing capacity)
If the vehicle/towbar has no D-value
b
Towbar load – rack weight = max. payload
Towbar Rack weight
load
110 lb
(50 kg)
132 lb
(60 kg)
154 lb
(70 kg)
≥ 161 lb
(≥ 73 kg)
Uebler i21 = approx. 29 lb (13 kg)
a See type plate on towbar
b If the values for the towbar and the vehicle are different, the
lower value must be used.
Power supply
Uebler i21, for max. 2 bicycles
Maximum tube diameter of bicycle frames
Round tube
Rectangular tube
Square tube
Attaching and removing the bicycle rack
Attention
The towbar and the vehicle must be suitable for mounting a
bicycle rack:
• Maximum towbar load (see type plate on the towbar and
vehicle operating manual)
• D-value of the ball head (see "Technical data" on page 14)
• The towbar must be made of St52-3 or stronger (see type
plate on towbar).
If not, the bicycle rack and the bicycles mounted on it may
come loose from the vehicle, injuring you and other persons, or
may cause an accident.
The ball head must be cleaned and degreased prior to
mounting.
Attention
Failure to take account of the altered vehicle dimensions
(width, height, depth) with the bicycle rack attached may cause
injury to you and other persons and/or cause damage to
property.
Please take account of the altered vehicle dimensions when
driving through entrances and narrow passages. Be careful
when reversing.
Attention
Check that the lights are in perfect working order before each
journey, otherwise accidents may occur.
a
(0) or the D-value ≥ 5.3 kN:
Max. payload
82 lb
(37 kg)
104 lb
(47 kg)
126 lb
(57 kg)
132 lb
(60 kg)
13-pin, 12 V
4.5 inch
(115 mm)
4.7x3.1 inch
(120x80 mm)
3.7x3.7 inch
(95x95 mm)
Note
Remove the bicycle rack from the vehicle when not in use. This
saves fuel.
Mounting the bicycle rack on the vehicle
1
1. Open the flap of the bag
2. Press the safety lever (11) so that the attachment (10) comes
out.
3. Hold the bicycle rack (1) upright and push it with the
attachment (10) onto the ball head of the towbar (19).
4. Tilt the bicycle rack (1) downwards until the safety lever (11)
audibly engages.
The red marking on the safety lever (11) must no longer be
visible.
5. Check that the bicycle rack (1) is parallel to the bumper and
roughly parallel to the ground.
Shake the bicycle rack (1) to check that it is firmly fitted. If
necessary, take off the bicycle rack (1) and mount it again.
1 The bag is available as an option (item no. 19840).
- 14 -
18
11
10
1
(18).
19
M+P-25A-0209