Miniland digitalk easy 89171 Manual Del Usuario página 15

ENGLISH
unit from anywhere (within the range of the signal of the apparatus).
- The rechargeable batteries should be charged for 16 hours before use for the first time or when
they have not been used for a long time.
Place the parent unit on the charger base (9) whenever possible in order to keep the batteries
charged at all times.
- Remove the cover to the compartment (8) on the rear of the parent unit by pressing and sliding
it down. Insert the rechargeable batteries in accordance with the correct polarity and replace the
cover (Figure 3).
- Place the parent unit on the charger base (9) (Figure 4).
- Plug the adapter into the mains. The On/Off and charge LED indicator (4) will flash green while
the device is charging. The LED indicator will light up green when the device is fully charged.
The baby unit:
The baby unit is designed to operate with the AC/DC adapter included.
- Connect the adapter to the base of the baby unit (Figure 5).
- Plug the adapter into a mains socket.
5.2. OPERATION
Turning the units on:
· The parent unit: press the on / off button (1) for two seconds. The On/Off and charge LED
indicator (4) will light up green.
· The baby unit: press the on / off button (10) for two seconds. The On / night light indicator (12)
will light up green.
Once the baby monitor has been prepared you will be able to hear the sounds captured in your
baby´s room through the parent unit. You will also be able to see how the LED sound indicators
flash: when the sound captured is low the first LED indicator (5) will flash red, however when the
sound captured is loud both LED indicators (5 and 6) will flash red.
Turning the units off:
· The parent unit: press the on / off button (1) for two seconds.
· The baby unit: press the on / off button (10) for two seconds.
5.2.1. Sound activation (VOX)
This function activates your baby monitor by sound when it is in standby mode.
If the baby unit does not detect any sound or the sound detected is below the sensitivity threshold
(fixed and established during the manufacturing process) for a period of 20 seconds, it will stop
transmitting. Nevertheless, it will continue to capture the sounds in the vicinity using a minimum
amount of energy. The parent unit will enter standby mode and will remain silent.
When the baby unit detects any sound above the device´s sensitivity threshold it will begin to
transmit the signal to the parent unit again.
5.2.2. Volume
You may set the desired volume to listen to your baby using the raise / lower volume buttons (2
and 3) on the front of the parent unit.
Selecting the volume level (9 levels) will not affect the sensitivity of your baby monitor, which features
factory configurations, but only the volume at which you will hear the sounds on the parent unit.
5.2.3. Charge and low battery indicator
The On/Off and charging LED indicator (4) in Parents Unit works as an indicator of the charging
process:
15