Night Light - Miniland digitalk easy 89171 Manual Del Usuario

ENGLISH
If the parents unit is off and it is placed on the charging base,
· The On/Off and charge LED indicator (4) will flash in red while the parents unit batteries are charging.
· When the batteries are fully charged this LED indicator (4) will light up red.
If the parents unit is ON on low radiation mode (LOW) and it is placed on the charging base:
· The On/Off and charge LED indicator (4) will flash in green while the parents unit batteries are charging.
· When the batteries are fully charged this LED indicator (4) will light up green.
If the parents unit is ON on zero emissions mode (ZERO) and it is placed on the charging base,
· The On/Off and charge LED indicator (4) will flash in yellow and red while the parents unit
batteries are charging.
· When the batteries are fully charged this LED indicator (4) will light up yellow.
The approximate charging time for the parent unit batteries is around 5 to 8 hours, depending on
the battery charge level at the onset of the process.
When the batteries are fully charged the average life of the parent unit is around 6 to 7 hours and
will depend on the listening / standby cycles. The maximum battery life will be around 10 to 12
hours in the event the baby unit remains in a silent environment for most of the time.
When the battery level of the parent unit is low, the parent unit will emit a warning beep every
30 seconds and the LED on / off and charge indicator will flash red. When this occurs, place the
parent unit on the charger base (9) in order to recharge the batteries. You may continue to use
the baby monitor while the parent unit is on the charger base.
5.2.4. Paging (searching for the parent unit)
This option serves to find the parent unit when it cannot be found. It is also very useful when one
of the parents is in the baby´s room and needs to contact the other parent.
Press the night light / parent unit search button (11) on the baby unit for 3 seconds. The parent unit will
emit a three-tone beep which you can deactivate by pressing any of the buttons on the parent unit.

5.2.5. Night light

The baby unit features a night light (12) which emits a soft glow, providing your baby with comfort
and enabling him / her to see in a dark room.
To turn the night light on or off press the night light / parent unit search button (11). Remember
that the night light is controlled by pressing the button (11) for a short time.
5.2.6. Mode switch: zero emissions (ZERO) and low radiation (LOW)
The baby unit features special transmission technology known as Zero Emissions. When the
baby unit is in standby mode and no sound is detected in the room, this unit emits no radiation.
The mode of communication between the two units may be selected using the emission mode
switch (LOW / ZERO) (13) on the base of the baby unit.
The mode used by the baby unit may be Low Radiation or Zero Emissions. Use the mode switch
(LOW / ZERO) (13) to select the mode.
1) Zero emissions mode (ZERO)
Setting:
Set the switch at the bottom of the baby unit (13) to the "ZERO" position. When both units (the
parents´ and the baby´s) are turned on the On/Off and charge LED indicator (4) on the parent
unit will light up in orange to show the ZERO mode has been selected.
Operation:
During normal baby monitor operations (LOW) the baby unit sends a regular beacon signal to
the parent unit informing that it is connected and operating, even when the baby unit does not
detect any sound.
16