Uv Mode; Scheduling - Amibot PURE LASER Manual Del Usuario

Operating the robot
NOTE:
• If the robot is in standby mode, press the power button on the robot once or
the AUTO button on the remote control to come out of standby.
• The robot's cycle can be interrupted and it can be manually controlled using
the remote control.

UV mode

You can enable or disable the robot's UV mode by pressing the UVC
button on the remote control.
NOTES:
• The UV light cannot be enabled while the robot is performing a cleaning cycle.
The UV light is off when the robot starts up, is paused, has an error, is charging
or is in standby.
• The UV light turns off immediately when the robot is lifted off the ground.

Scheduling

Scheduling can only be performed via the AMIBOT HOME mobile
app. Set your preferred daily cleaning times via the mobile app.
17
EN