Cleaning Modes; Auto Mode - Amibot Animal Motion Manual De Instrucciones

Operating the robot
NOTE:
• If you wish to use the robot on a daily basis, make sure the home base is turned
on and that the robot's power sensors are in contact with the home base's
contacts.
• To perform a scheduled clean, the robot must be out of standby mode and
must not be in operation. If this is the case, you must pause it.
• Scheduled cleaning and the remote control times are cancelled when the
batteries are changed. Reset the time and scheduled cleaning time as above.

Cleaning modes

The robot has five cleaning modes. These modes can be selected
using the remote control. AUTO mode can also be selected on the
top of the robot.

AUTO mode

Press the AUTO button on the robot or on the remote control.
The robot uses its laser module to scan the room to optimise its
movements. It first divides the room into areas in Wall mode and
then moves in a zig-zag fashion to vacuum any debris and dust.
During an AUTO mode cleaning cycle, the robot may take a short
19
EN