Visitor Codes - Steren SEG-150 Manual De Instrucciones

To clear all the cards and PINs in the system, enter the following sequence:

Visitor codes

You can set up to 50 visitor codes in two operating modes: for use only once
(delete code after use) or time limit (after a determined time the code is
erased). To enable a visitor code, enter programming mode and press the
following sequence:
40 + 01-50 + 00 or 01-99 + Visitor code + #
Where:
40 to indicate that it will record a visitor's code.
01-50 is the visitor's identification number (between 01 and 50).
There are two operating modes:
00 if it will be used only once (after first use, the code will be deleted).
01-99 is the time interval before the code is deleted (in hours).
Visitors code must be between 4 and 8 digits.
# to confirm.
To delete ALL invited codes, enter the following sequence:
10 + 0999 + #
40 + 0999 + #
17