Configure The Door Opening; Security Lock - Steren SEG-150 Manual De Instrucciones

Configure the door opening

The opening of the door can be programmed in two forms: open and close or
time. On the open and close mode the door will open when you enter a PIN or
a card read, and will be closed until you enter a PIN or a card read. In the time
mode, the door will be open the indicated time.
To set the open mode, enter the programming mode and enter the following
sequence:
51 + 0 or 1-99999 + #
Where:
51 to indicate that it will set the door open mode.
0 for the open and close mode.
1-99999 to select the time mode. The number you enter here will be the time
(in seconds) that the door remains open.
# to confirm.

Security lock

To prevent the introduction of more than a certain number of wrong codes,
you can program a security lock. The unit comes preprogrammed so that after
10 attempts to enter a wrong PIN, the door is locked for 60 seconds. You can
set the number of attempts before the door is locked. Enter the programming
mode and press the following sequence:
60 + 1 or 5-10 + #
18