Velleman VELBUS VMB1DM Manual Del Usuario página 3

7
ADDR.
Mode
14
Time
9
Term
ON Rx Tx
10
8
1 Load contact
115VAC connection
2
230VAC connection
3
4 12V supply
5 Velbus
Mode
6 Direct push button control
7 Mode-LED :
13
12
8 Velbus TX (transmit) LED
9 Power LED
11
Velbus RX (receive) LED
10
11 Manual control
12 Time setting
13 Control mode setting
15
Address setting
14
Enter a unique address (from '00' to 'FE' except for '81', '91', 'A1', 'B1', 'C1',
'D1', 'E1', 'FE' and 'FF') for each module through
15 Termination
If the module is connected at the start or end of a cable on the VELBUS, place the
'TERM' jumper
Remark: If different cable wiring topologies (tree, star, loop, ...) are used, place a
jumper on the end module of the longest cable only, NOT on each end point.
.
The LED will burn if the lamp does not light up.
The LED will burn if the lamp burns at a stable light intensity.
The LED blinks rapidly as long as the lamp's light intensity is modifying.
The LED blinks slowly when the switch-off delay is running.
The LED blinks very rapidly if the dimmer module is set in learning mode.
ENGLISH