Safety Rules - Promax DT-421D Guía Rápida De Configuración

QUICK CONFIGURATION GUIDE DT-421D

2. SAFETY RULES

2.1 General
∗ The safety could not be assured if the instructions for use are not
closely followed.
∗ Use only with other DT series modules and for power supply and Control
those indicated at the Specifications.
∗ Remember that voltages higher than 70 V DC or 33 V AC rms are
dangerous.
∗ Use this instrument under the specified environmental conditions.
∗ The user is not allowed to perform changes inside the equipment. Any
change on the equipment must be done exclusively by specialized staff.
∗ Do not obstruct the ventilation system of the equipment.
∗ Use appropriate low-level radiation cables for input / output signals,
especially on high level signals.
∗ Follow the
paragraph.
∗
Symbols related with safety:
07/2012
cleaning instructions described in the Maintenance
Page 5