Allmand MAXI-LITE Manual Del Operario página 18

To adjust for towing
Note: Six-light LED model shown. All other models similar.
1. Set the light bar to the towing position.
a. Pull the park pin and rotate 90° to unlock the light bar.
b. Rotate the light bar as shown in Figure 15.
c. Pull the park pin and rotate 90° to lock the light bar.
2. Set the tower arms to the transport position.
a. Loosen the adjustment nut on each tower arm.
b. Pull and rotate the park pin to unlock each tower
arm.
c. Rotate each tower arm to set the light fixture yokes
as shown in Figure 15.
d. Pull and rotate the park pin to lock each tower arm.
e. Tighten the adjustment nuts.
3. Rotate the fixture yokes and adjust the light fixtures so
that the light fixtures face inward toward center. See
Figure 15. On LED models, lock the light fixtures with the
park pins.
15
To adjust for transporting on a trailer / storage
Note: Six-light metal halide model shown. All other models
similar.
1. Set the light bar to the transport position.
a. Pull the park pin and rotate 90° to unlock the light bar.
b. Rotate the light bar as shown in Figure 16.
c. Pull the park pin and rotate 90° to lock the light bar.
2. Set the tower arms to the transport position.
a. Loosen the adjustment nut on each tower arm.
b. Pull and rotate the park pin to unlock each tower
arm.
c. Rotate each tower arm to set the light fixture yokes
as shown in Figure 16.
d. Pull and rotate the park pin to lock each tower arm.
18
e. Tighten the adjustment nuts.
3. Rotate the fixture yokes and adjust the light fixtures so
that the light fixtures face downward. See Figure 16. On
LED models, lock the light fixtures with the park pins.
16
Raising And Lowering The Light Tower
WARNING
Crush Hazard
• Raising or lowering the light tower with obstructions
or people near the light tower could result in death or
serious injury. Be sure the area is clear of people and
obstructions before raising or lowering the light tower.
Note: The engine does not need to be running to raise or
lower the light tower.
To raise the light tower
1. Move the tower switch on the control panel to the UP
position to raise the tower to the preferred height.
To lower the light tower
1. Turn the tower lights off before lowering the light tower.
See Operation - Operating The Tower Lights.
2. Move the tower switch (A, Figure 17) on the control panel
to the DOWN position until the tower is fully lowered.
3. Hold the tower switch in the DOWN position for three
additional seconds, to make sure the tower is fully
lowered.