Bathtub Installation; Symbols And Descriptions - PEERLESS Selva Manual De Instalación

BATHTUB INSTALLATION

Important Instructions For Proper Installation
Bottom support
Bottom support
 CAUTION: Entire bottom support must be in contact with a fl at, level surface.
 CAUTION: IMPROPER INSTALLATION may result in failure of this unit.
TIP: If installation surface is not level, use leveling compound or mortar bed for proper installation.


1. Symbols and Descriptions

 APPLY ADHESIVE where indicated. Apply 1/4" to 3/8"
round bead.
 APPLY SEALANT where indicated.
 CAUTION: A situation which, if not avoided, could
result in property damage or other undesirable conditions.
Product damage will occur and will void the warranty.
IMPORTANT! Instructions which, if not followed, could
result in property damage. Product damage may occur
and will void the warranty.
Installed correctly
Wall
To ensure base is
installed correctly,
entire bottom support
must contact a flat,
level surface.
Do not install the product with any air gaps under
the bottom support or product damage will occur.
Wall
Air gap
Shim
2. Attach Apron Support
Apron
support
Apron
IMPORTANT! Protect bathtub fi nish by overturning it
onto a clean, soft surface such as a drop cloth.
 APPLY ADHESIVE where noted.
◘
Attach apron support to bottom support.
◘
Tape in place until adhesive dries.
4
Wall
Ledger strip
Bottom
on wall
support
Tape
P/N 27751 8/10
Air gap
Bottom
support