CONTROL PANEL (fig.1)
Indicator
- signals that the water tank is full.
The indicator will light up in red when the capacity of 2 l is reached.
This will additionally be indicated by a sound; then, the appliance will turn off.
Then empty the water tank and put in back in the right position.
Indicator
- indicates that the device is connected to the power supply.
"POWER" button
- intended for turning the appliance on/off
To turn the appliance on, press the
button.
When turning on the appliance for the first time and after connecting it to the power
supply, a standard program with a default setting of a relative humidity level of 60% RH is
activated.
After turning off the appliance with the
button, it will save the set parameters (selected
program, relative humidity level setting).
After disconnecting the power supply, the appliance will reset to the factory settings.
Do not directly remove the power cord plug to force the appliance to stop.
MODE
- programme selection.
To select a saved programme, press the
key until the corresponding lamp on the
display lights up: „A", „CNT",
.
Automatic program - lamp „A" on the display
In automatic mode, the device switches on when the air humidity is 3% higher than the set
value. First the fan starts operating and after about 3 seconds the compressor starts up.
When the air humidity is less than the set value by 3%, the compressor switches off and the
fan is still running for about 30 seconds.
A 3-minute delay of the compressor is programmed in the device, which means that
despite the increase in humidity, the dryer will not always switch on immediately.
In automatic mode, both the fan speed and the humidity setting can be adjusted.
Continuous dehumidification program - „CNT" lamp on the display
In continuous dehumidification mode, the compressor operates continuously and the fan
speed is set to „fast". It is not possible to set the humidity level or change the fan speed.
Night programme - lamp on the display
In night mode, the fan speed is automatically switched from high to low.
After about 10 seconds of inactivity, the indicators gradually go out. Pressing any button
25