nurse Roller Instrucciones página 21

GB
A s s e m b l y
1 OPEN THE STROLLER
Remove stroller from box. the front wheels, rear wheels and front bumper need to be installed
prior to use.
First check whether your stroller is equipped with a latch, which holds the stroller's frame to-
gether. see fig 1
• Lift the handle bar as shown in fig , 2 until the top and bottom part of the frame locks into one
another. (see fig. 3)
• If your stroller is equipped with a second safety lock, please engage it now.
2
INSTALLATION OF REAR WHEEL
Assemble the rear axle as follow. Insert the axle through each wheel, with axle going through the
brake cluster on the wheel first. Snap the small lock cap at the end ofthe axle to lock the wheel
on. Lastly, snap the hub cap into place. Pull on each wheel. To ensure that each is securely locked
onto the rear axle.
INSTALLATION AND UNLOAD THE FRONT WHEEL
3
To load the front wheels, push each front wheel onto the front wheel bayonet until snapped into
place. Pull on the wheel to ensure that it is securely attached to the stroller.
To unload the front wheels, push the quick release button to unload the front wheel.
INSERTING THE SEAT
4
TO ATTACH THE CANOPY
Insert the black set on both sides in the seat hold (1)
Press the end to unload the canopy (2)
TO ATTACH THE SEAT
Cross the strip on the iron line and attach the snaps.
Attach the seat on the frame.
TO REMOVE THE SEAT
Press the buttons on both sides, then lift the seat
INSERTING AND UNLOAD THE FRONT BUMPER
5
Align the front bumper with the fitting on the stroller frame as below shown.
Insert the bumper into the fittings by gently pushing the bumper until you hear a click sound and
the release buttons pop-out in the slot on the frame fittings.
6 FITTING THE HARNESS
To attach the harness-insert both fasteners securely into the clasps adjust each strap length as
required.
To undo the harness-press the fasteners buckles and pull apart .
Operating
7
BRAKE
To engage brakes, apply light downward pressure to the brake lever located on the middle of
rear wheel axle. The stroller may require slight forward or rearward movement in order to line up
the teeth on the brake with each wheel brake cluster. Check that the stroller will not move and that
the brakes are properly applied. To release, gently lift up on the brake lever.
INSTRUCTIONS
21