Rola 59972 Guía De Instrucciones página 10

INSTALLATION INSTRUCTIONS
10. Position and tighten the cross bar assemblies over
the fixed point set screws. Follow the fit kit
instructions for complete installation instructions.
Fig. A and Fig. B.
CAUTION: be sure to read your fit kit instructions
completely for vehicle specific information not
shown here.
11. Lock the FPE end supports and rails into position
by closing the cam levers as shown in Fig. C,
rechecking that the rails are centered on the
vehicle.
Note: Careful not to pinch fingers or hand!
Fig. A
Fig. B
Fig. C
PAGE 10 59972N Rev A • Questions? (800) 234-6992 • ROLAProducts.com