Rola 59967 Instrucciones De Instalación

Note: Prior to Assembly
Prior to assembling your Crossbar kit check that the kit
contains all the parts you will need to fit the Crossbars. Refer
to parts lists for guidance. L-Wrench is stored in the End
Support.
Please read these instructions before assembly.
Step 1:
Loosely Assemble the 40mm Bolt through the end support, Adapter foot
and the Strap/Nut assembly to each of the 4 end supports as shown below
in Fig. 1
Step 2:
Guide the End support and Strap down into the
roof rail channel until it is resting on it as
shown in Fig. 2
Fig 2
59967N Rev: B 10/13/2015
Fitting Instructions
2011-ON
(Jeep Grand Cherokee with roof rails)
Crossbar Kit
Fig 1
Step 3:
Push the strap into the end support and under
the lip on the roof rail (push away from the
vehicle center). Check that the Strap is pushed
into position correctly as Shown in Fig. 3a, 3b &
3c before continuing to step 4
PUSH
Fig 3a
Towards center of vehicle
Printed in China
PART No:
CARRYING CAPACITY:
Parts list
Key (4)
Crossbar / End Support
Assembly FRONT is labeled
Plastic adaptor (4)
PUSH
Strap not pushed in
59967
75Kgs/
165 Lbs
FRONT
L-Wrench – Security
Key(2) (Stored in End
Support)
40mm
Strap / Nut assy. (4)
Bolt (4)
CORRECT
Fig 3b
INCORRECT
Fig 3c
Pg 1 of 2