Samoa PM80 Serie Guía De Servicio Técnico Y Recambio página 7

REPAIR AND CLEANING PROCEDURE
AIR MOTOR SEALS (FIG. 7)
57
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
94
2
3
4
5
6
7
8
10
9
10
13
30
10
31
32
33
34
34
38
40
39
41
39
36
37
38
42
43
92
44
Fig. 7
1. Unscrew bolts (2) and lifting nuts (94), then remove cap (3).
2. Unscrew the sensor sleeve (4).
3. With a manual clamp on the nut (5), pull the rod on the air piston
assembly (37) outwards until its central recess appears (fig. 7a). Then,
with another manual clamp, grab said rod on said recess to prevent
its sealing surface to be damaged, and unscrew the nut (5) (fig. 7b).
4. Remove O-ring (6) and ring (7), and replace them with new ones later.
5. Unscrew bolts (44, 92). Pull the motor head (13) upwards to free
it along with flange (34).
6. Take away the gasket (8) and replace its seals (9) and (10).
7. Unscrew 5 bolts (35) and split motor head (13) from the flange
(34). Take away the washer (30) and replace the seal (10).
8. Take away the cylinder (40) while carefully holding the air piston
(37). Replace the piston seal (36).
9. Reassemble in reverse order, applying thread locker in screws (35),
nut (5) and sensor sleeve (4).
NOTE: all these seals are included in the available kit 534904.
EN
Fig. 7a
Fig. 7b
7
R. 02/20 853 831