Promax DT-800 Manual De Usuario página 61

CONTROL MODULE. DT-800
The automatic position assignment does not have any practical effect. Each time
you restart the DTTV, the control module will assign different positions to each module.
If you do not like this way to assign, Then you can create and save your own assigment.
In this way, your assigment will remain unchanged.
Verify that the modules appearing in the list correspond with the installed and its
status is OK.
Note that dual modules, such as the DT-102 or DT-302, are treated as two
separate units that must be configured independently.
In contrast, the module DT-7XX, will not appear on the list even if they are
installed in the headend.
If there is some problem, it will appear the name of the module in the STATUS
line and in the line below a brief description of the problem (Fig. 10.-).
If there are more than one module working wrong, the names of these module will
appear sequentially at the bottom of the screen. Next to the name is shown a number
indicating the order of the module for total modules with errors.
04-2012
Figure 9.- Main Screen.
Figure 10.-
Page 15