Configuration; Description Of The Initial Setup Screen - Promax DT-800 Manual De Usuario

CONTROL MODULE. DT-800
3.- If you want to change a number, press UP
to decrease.
4.- Once the value is edited, press ENTER
value.
After entering the password and if it is correct, you will access the setup menu.
If the password is not correct, you can make a new attempt.

4.7 CONFIGURATION

After turning on the unit, wait until the checking of all the units connected to the
control unit is done.
After the checking, press ENTER
CONFIGURATION login screen.
After entering the PASSWORD you will access the settings.
From the starting screen, you can select the module you want to access in order
to edit its settings (Fig. 10.-). To do it, use the keys LEFT
among the available modules.

4.7.1 Description of the initial setup screen

At the top of the screen appears "SELECT MODULE" and at the top right corner
a fractional number indicating the position of the currently selected option over the total
amount of menu options.
At the central area of the screen it appears the name of the module (Fig. 12.-), on
the figure is the DT-800 control unit. Note that the system counts the double modules
like two different units and the configurations of them are independent.
At the bottom area, the first line shows the message "LINK TO: ..." and then the
name of a module. This message indicates the modules the unit control is connected to
and have been detected during the scan after starting. The second line shows the
number of modules found, excluding the control unit.
04-2012
to increase or DOWN
to confirm the entered
on the frontal equipped to get into the
or RIGHT to move
Page 17