Promax DT-800 Manual De Usuario página 75

CONTROL MODULE. DT-800
6.- After obtaining the data, the DT-302 dual module is configured in order to
tune the channels selected. Turn on the
settings. Due to it is a dual module, each unit has to be set separately.
Receiver 1:
LNB Local Oscillator: According to the data collected, it is a vertical
polarization. Therefore is 9750 MHz.
DL-Frequency: 11,541.
DL-Band: For the European area is Ku-band.
LNB: For vertical polarization, 13V.
Standard: It is a normal digital channel, therefore DVB-S.
Symbol Rate: 22000.
Service List: Select the services: "Channel 50" and "TV7 Lombardia
(Although it has capacity for many more).
Receiver 2:
LNB Local Oscillator: This is a horizontal polarization. It is therefore
10,600 MHz
DL-Frequency: 11,604.
DL-Band: For the European area is Banda C.
LNB: For horizontal polarization, 18V.
Standard: This is a normal channel of digital quality, it's DVB-S.
Symbol Rate: 22,000
Service List: Select the services "Das Erste" and "RTL 2 Schweiz."
(Although it has capacity for many more).
7.- Once set the DT-302, you should set the DT-102 in order to adjust the output
frequency of the channel.
8.- The output signals of the DT-102 is the combination of the two inputs from the
DT-302, therefore you will get a single RF output with services of the German
and Italian channels. Now only rests to mix it with the DTT signal from the
national broadcasters.
9.- The DT-710 is used to combine the signal from the DT-302 and the DTT
signal. The combiner mixes both two and get the result.
04-2012
Frequency: 11,604.
Polarization: Horizontal.
Symbol Rate: 22000.
FEC: 5/6.
Standard: DVB-S QPSK.
and enter, step by step, all the
Page 29