Technical Data; Filling The Magazine; Noise/Vibration Information - REICH HOLZ-HER 3533 Datos Técnicos

4
1

TECHNICaL DaTa

Type
Dimensions mm
Weight kg (without fasteners)
Contact actuation
Recommended operating pressure
range
Maximun permissible operating
pressure
air consumption per driving
operation
Magazine capacity No. of fasteners
Penetration depth setting
Fastener: paper bound nail strips
Nail length mm
Nail shank Ø mm
Recommended lubricant
1 litre special oil. Code No.
50 cm3 grasa especial. Code No.


NoISE/VIBRaTIoN INfoRMaTIoN

Noise characteristic values *
a-weighted single-event emission
sound pressure level at work
station L pa, 1s
a-weighted sound power level
L Wa, 1s, d
Vibration characteristic values **
Weighted r.m.s.-acceleration (a),
a h, w, 3s
The noise level when working can exceed 85 dB (a).
Wear ear protection!
* Measured values determined according to
EN 1549:1999.
** Measured values determined according to
ISo 866-11:1999.
3 SUPPLIED WITH
1 Strip magazine Nailer
1 Tool use and safety instructions
1 Technical data sheet
4
3533 only those fasteners specified under technical data
(see 1) may be used.
363/353
When filling the magazine, hold the tool so that the
3,6 kg
muzzle is not pointing towards own body or towards
any other person.
Do not load the tool with fasteners with the safety
6 - 8 bar/0,6
yoke or trigger depressed.
- 0,8 MPa
Push the two nail strips over the spring (47) into
8 bar /
the magazine (46a1). Make sure the nail strips are
0,8 MPa
positioned correctly in the magazine.
,9 l at 6
Pull the pusher (38a) backwards over the very last
bar / 0,6 MPa
nail of the strip.
56-70
Remove the nail strip from the magazine by pushing
yes
the lever on the pusher, causing this to jump forwards.
The nail strip can now be pulled out backwards, keep
the spring pushed down out of the way.
64-100
,8-3,4
5
9 440
The penetration depth of the nail head can be controlled
68 3868 by means of the air pressure. If this is not satisfactory,
the penetration setting of fers a more accurate
adjustment of the penetration depth. adjustment is
only possible in the unpressurized condition.
The penetration depth setting can be moved by one
3533
or more notches by loosening the screw (n) and the
safety yoke (a). for safety reasons, this should only
be carried out in a depressurised state.
94 dB(A)
Retighten the screw.
103 dB(A)
6
3,15 m/s2
Balancer for 30-55 N (3.0-5.5 kp),
cable travel .0 m (6.5 ft)

fILLING THE MaGazINE

fIL PENETRaTIoN DEPTH SETTING
aCCESSoRIES
Code No.
73 0715