Adjusting The Display Contrast - Elkron FKP500 Manual De Instalación

When data communication between control panel and remote panel is interrupted, following
massage appears on the display and the buzzer is activated. To locally silence the buzzer, press
key "ACK" (Acknowledge)
*** FAULT *** COMMUNICATION FAILURE
When control panel is being programmed, following information will be shown on remote panel
display.
5.1

ADJUSTING THE DISPLAY CONTRAST

The display contrast can be adjusted as follows:

With the panel turned on, press the "Lamps Test" and "<" keys at the same time.

The contrast adjustment bar and ambient temperature will appear on the display.

To increase the contrast, press the "Lamps Test" and "" keys at the same time.

To decrease the contrast, press the "Lamps Test" and "" keys at the same time.

To exit the adjustment menu, press the "Lamps Test" and ">" keys at the same time.
The contrast adjustment value is lost when the panel is turned off.
CONSOLLE ID 10
CONSOLLE ID 10
REMOTE PROGRAMMING ENABLED
23