Blade Assembly; Light Kit Assembly (Optional) - Craftmade Tempo 44in Manual Del Usuario

8. Blade Assembly.

Time Saver: Washers for blade screws can be set on
each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers in
hardware pack. Slide blade through one of the narrow,
rectangular openings on motor housing, aligning holes
in blade with holes in blade arm (located on the INSIDE
of the motor housing and can be seen from the
UNDERSIDE of the motor housing)--REFER TO
DRAWING AT RIGHT. Insert 3 blade attachment screws
(along with washers) with fingers first and then tighten
screws securely with a Phillips screwdriver. Repeat
procedure for each remaining blade.
NOTE: Tighten blade attachment screws twice a year.

9. Light Kit Assembly (Optional).

Remove 1 screw from motor plate (on underside of
motor) and partially loosen the other 2 screws. Align
slotted holes in fitter plate with loosened screws in
motor plate, allowing female plug from motor
housing to come through hole in middle of fitter
plate. Twist fitter plate to lock. Re-insert screw that
was just removed and tighten all 3 screws securely.
[Refer to diagram 1.]
Remove 1 screw from post on underside of fitter
plate and partially loosen the other 2 screws.
Connect female plug from motor housing to male
plug from LED light kit, matching up the colors on
the female plug with the colors on the male plug for
correct fit. Be sure that plugs connect securely. [Refer
to diagram 2.]
Carefully arrange wiring within LED light kit. Align
slotted holes in LED light kit with loosened screws in
fitter plate. Twist LED light kit to lock. Secure all 3
screws with a Phillips screwdriver. [Refer to
diagram 2.]
Align grooves on glass shade with nodules on inside
of LED light kit and push up gently on glass shade.
Twist glass shade to the RIGHT (clockwise) until
glass shade no longer turns. [Refer to diagram 2.]
Pull down VERY GENTLY on glass shade to make sure
that glass shade is secure.
If you do NOT wish to use the light kit,
on metal cover and align with nodules inside
light kit. Gently push up on metal cover and turn to
the RIGHT (clockwise) until it no longer turns.
to diagram 3.]
WARNING: Do NOT connect the male and female
plugs for the LED light kit if you do NOT wish to use
the light kit.
motor plate
female plug
diagram 1
diagram 2
locate slots
LED
[Refer
diagram 3
page 7
blade arm
(inside motor
housing)
motor housing
blade
blade attachment
screws and washers
motor
housing
fitter plate
motor
housing
fitter plate
female plug
male plug
LED light kit
glass shade
metal cover