WIKA FSD-4 Manual De Instrucciones página 24

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6. Faults
Warnings and errors
Via the digital display, the instrument's internal errors are displayed. The following table shows the error codes and their
meaning.
EN
WARNING
ATT1
ATT2
ATT3
ATT4
ATT5
ILOC
SC
PAS
OL
Error
ERR
ERR1
ERR2
Acknowledgement of an error display by pressing the "Enter" key.
24
Description
On changing the switch point, the reset point of the instrument is automatically reduced
Trim function cannot be executed because a parameter is outside the permissible limits
For flow unit %: Smallest span for teach function not maintained
For flow units other than %: Offset or correction factor is outside the permissible limit
Password entered for menu access is incorrect
The entire measuring range cannot be displayed. DiOL ("display overload") is shown outside the display range
Maximum turndown exceeded
Menu locked over IO-Link
Short circuit of output 1 or/and output 2
Prompt for password input
Overload, measuring range exceeded > approx. 25 % (display blinks)
Description
General error
Reset to factory setting
Restart the instrument
Ambient conditions outside the specification
Supply voltage too low
Internal temperature at display too high
Sensor error
WIKA operating instructions flow switch, model FSD-4

Publicidad

Tabla de contenido
loading

Tabla de contenido