Dip Switch Setting On The Radio Piggy-Back - SMA BEAMPB-NR Manual Del Usuario

Installing a Radio Piggy-Back in an Inverter

1.2 DIP Switch Setting on the Radio Piggy-Back

The Radio Piggy-Backs can be set to groups via the DIP switches (0 to 15, see figures below). This
allows you to exclude other inverters when recording data with the Sunny Beam, if to many other
inverters in the vicinity are set to the same group. The Sunny Beam and the Radio Piggy-Backs must
always be set to a common group. The Piggy-Backs are set to group 1 by default.
You can change the group for the Radio Piggy-Back
by pushing the white DIP switches on the Radio
Piggy-Back (see figure at right) up or down. Please
refer to the overview to find out which position of the
switches corresponds to which group. See the
Sunny Beam Documentation on how to change the
group setting for the Sunny Beam.
Overview of Radio Piggy-Back group settings
(factory setting)
16 BEAMPBNR-BXX072623
0
1
2
3
4
5
6
7
8
9
10
11
SMA Solar Technology AG
DIP switches
12
13
14
15