Protecting The Pump; Storing The Engine - Briggs & Stratton CleanShot 2050PSI Manual Del Propietário

CleanShot
TM
2050 PSI PressureWasher
CleanShot
PREPARING THE UNIT
FOR STORAGE
Water should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump parts and
"freeze" pump action. If you do not plan to use the
pressure washer for more than 30 days,follow this
procedure:
I. Flush chemical injection hose by placing filter into a pail
of clean water while running pressure washer in low
pressure mode (adjustable nozzle in forward position).
Flush for one to two minutes.
2. Shut off engine and let it cool, then remove high
pressure and garden hoses.Disconnect spark plug wire
from spark plug.
3. Placethe spray gun, nozzle extension, turbo nozzle,
utility brush with adapter and high pressure hose in the
accessory storage bag.
4. Empty pump of all pumped liquids by pulling recoil
handle about 6 times.This should remove most liquid
in pump.
5. Use PumpSaverto prevent corrosion build up and
freezing of pump.
6. Store unit in a clean,dry area.
Protecting the Pump
To protect the pump from damagecaused by mineral
deposits or freezing, use PumpSaverto treat pump.This
prevents freeze damageand lubricates pistons and seals.
NOTE: PumpSaveris availableas an optional accessory.It
is not included with the pressure washer. Contact the
nearest authorized service center to purchasePumpSaver.
CAUTION
• Failure to do so will permanently damage your pump and
render your unit inoperable.
• Freezedamageis not coveredunder warranty.
CAUTION
Always wear eye protection when using PumpSaver.
To use PumpSaver, make sure the pressure washer is
turned off and disconnected from supply water. Read and
follow all instructions and warnings given on the PumpSaver
container.
NOTE: PumpSaverwill drip from pump after treatment
and will stain wood and concrete.
NOTE: If PumpSaveris not available,draw RV antifreeze
(non-alcohol) into the pump by pouring the solution into a
3-foot section of garden hose connected to inlet adapter
and pulling recoil handle twice.
STORING THE ENGINE
See the engine owner's manual for instructions on how to
properly prepare the engine for storage.
I
14