Briggs & Stratton CleanShot 2050PSI Manual Del Propietário página 15

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CleanShot
TM
2050 PSI Pressure Washer
CleanShor
TROUBLESHOOTING
Problem
Pump has following problems:
failure to produce pressure, erratic
pressure, chattering, loss of
pressure, low water volume.
Detergent fails to mix with spray.
Cause
I.
Nozzle in low pressure mode.
2.
Water inlet is blocked.
3.
Inadequate water supply.
4.
Inlet hose is kinked or leaking.
5.
Clogged inlet hose strainer.
6.
Water supply is over 100°E
7.
High pressure hose is blocked or
leaks.
8.
Gun leaks.
9.
Nozzle is obstructed.
10. Pump is faulty.
I.
2.
3.
4.
Detergent siphoning tube is not
submerged.
Chemical filter is clogged or
cracked.
Dirty in-line filter.
Nozzle is in high pressure mode.
Correction
I.
Pull nozzle backward for high
pressure mode.
2.
Clear inlet.
3.
Provide adequate water flow.
4.
Straighten inlet hose, patch leak.
5.
Check and clean inlet hose
strainer.
6.
Provide cooler water supply.
7.
Clear blocks in outlet hose.
8.
Replace gun.
9.
Clean nozzle.
10. Contact Briggs and Stratton Power
Products service facility.
I.
Insert detergent siphoning tube
into detergent.
2.
Clean or replace filter/detergent
siphoning tube.
3.
See "Check In-Line Filter".
4.
Push nozzle forward for low
pressure mode.
Engine speed is too slow.
Move throttle
control to FAST
Engine runs good at no-load
but
position. If engine still "bogs down",
"bogs"
when load is added,
contact Briggsand Stratton service
facility.
Pressure
washer
stops during
Out of gasoline.
Fill fuel tank.
operation.
/
15

Publicidad

Tabla de contenido
loading

Tabla de contenido